|
 Materials Required
Stockings- various colours
Silver Wire
Thread
Green Tape
Pips -Various Colours
Scissors
Method
You can make a variety of
flowers using stockings. All you need is a little imagination and
creativity . So let your imagination run wild.
Petals
Take  a thin wire and cut out several pieces of approximately 6" length from it. Keep it aside.  Now take one of the 6" piece wire and
fold it to get an oval shape. Make it look like a heart shaped petal,
by dipping the centre of the oval a bit and pulling on either sides with
your hands.
Make three petals like this. Now take the stockings and pull it over the
petal tightly and tie at the end using thread. Cut off the excess
stocking. Cover the three petals with the stockings similarly.
Stalk or stem
 Decide on the length of the stalk. Say if its about 12", cut a
24" length piece from the wire and fold it in exactly half. So that
the stem will look thick. At the end of the stalk make a small bend to fix
the pips.
 Take 3-4pips and fold it at the centre. Insert the pips through the
bend of the wire.
Tie it in place using thread.
After this place the three petals around the pips and tie a knot again
using the thread. Then wind the green tape around the stock completely.
Now your flower is ready.
 The
procedure to make the leaves is the same. First make the loop as mentioned
earlier and shape it like a leaf and cover with green stockings. Wind the
green tape around the leaf stalks. Make 4-5 such leaves and attach to a
long stalk using green tape.
You can arrange these flowers
in a vase.
| 
