 |
Materials
-
Fish
wire
-
Thin copper wire
-
Green Tape
-
Cotton
-
Satin
cloth
-
Thread
|
 |
Method
Fish wire
is a broad plastic tape with thin lines on it. Take few pieces of the fish
wire, of 6 inches each.  From
one end of each piece, leave one inch and cut along the lines without separating
it, keep it aside. Take a copper wire (used for the stem) of 10 inches
length. With cotton, make a small bud, cover it with the satin cloth (as
shown in the picture), tie this to the top end of the wire, the center part of
the flower is ready. The length of the stem can be made long or short.
Tie the 6 inch piece fish wire petals to the  wire (Stem). Now tie petal by petals around the bud, (tie them firmly to the stem
wire because the satin cloth and the plastic fish wire are quite smooth) Until
it turns out to be a thick flower. Using the green tape wrap the stem wire to
the end. The flower is ready and can be arranged with fresh leaves. This flower
is washable, while washing, the stem should not get drenched. Fish wire is available
in many colours, so colourful flowers in different shades can be made.
|
