 Materials
Required
Procedure :
-
 At
first, take the tissue paper and cut it equally into four strips.
-
Now attach three of these strips to make a long strip.
-
 Fold
this long strip equally making it to about one fourth of its full length.
-
Using a scissors, cut its edges and later unfold the strip of tissue.
-
 Take
the aluminium wire and fold its edge.
-
Dip its edge in glue.
-
 Slowly
wind the tissue paper around the wire. As you wind, crush the paper (at
the folding edge) for a filling look, at small intervals until you wind
the whole strip.
-
Now tighten the same aluminium wire or thread around the flower for support
and to prevent from falling off.
-
 Wind
the green tape around the wire to make the stem.
Your flower is ready. Arrange
with fresh ferns for an attractive look.
Another
Method with Tissue or organdi cloth material :
Materials Required :
Cut out 7 to 8 round pieces (5cm diameter)
from the organdi cloth. Fold the circles twice to make a cone shape and cut the
round edges finely. Open out the circles. Cut out two long strands of thin wire.
Fold one circle pieces and wind a long strand of wire at the end. Take one more
circle and do the same. Keep both together and plait the two wires together. Wind
the green tape around the wires (stem). Make a pin hole at the centre of the rest
of the circles and insert this one by one through the wire from below. Tie it
with a green thread to keep it in place.
|
